Encore Forums Encore Forums

Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums 

Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Error: "Cannot Determine Configuration"

 
Logged in as: Guest
  Printable Version
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM Tech Tips >> Error: "Cannot Determine Configuration" Page: [1]
Login
Message << Older Topic   Newer Topic >>
Error: "Cannot Determine Configuration" - 4/7/2009 12:36:22 AM   
Brandy redux


Posts: 2376
Joined: 2/7/2007
Status: offline
The "Cannot Determine Configuration" error message is often the result of a corrupt installation.

Following is the recommended solution for this problem:

A. Click on this link

Uninstalling Software: Thoroughly & Safely

then follow the directions in that FAQ

To make sure that all remnants of the program have been removed, it is VERY important to follow ALL directions in that FAQ for searching the hard drive. It is also VERY important to keep in mind that the registry should NOT be edited manually to remove remnants of the program. Instead, the registry should be cleaned ONLY by performing Step #4 in the "Computer Cleanup on WinXP & WinVista" FAQ recommended below.

B. Click on this link

Computer Cleanup on WinXP, WinVista & Win7

then follow the directions in that FAQ for performing a computer cleanup.

To make sure that all problems have been found, it is VERY important to perform ALL 7 steps. It is also very important to NOT perform any procedures that are not recommended in this FAQ.

C. Click on this link

'Clean' Install on Win98/Me/XP/2000/Vista/Win7

then follow the directions in that FAQ.

< Message edited by Brandy redux -- 5/23/2011 12:21:46 PM >


_____________________________

For More Help:
Click on the FAQ link at the top of this page
Then, click on the All FAQ's button on the next page

To contact me by email, please send your message to pine_97@yahoo.com
Post #: 1
Page:   [1]
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM Tech Tips >> Error: "Cannot Determine Configuration" Page: [1]
Jump to:





New Messages No New Messages
Hot Topic w/ New Messages Hot Topic w/o New Messages
Locked w/ New Messages Locked w/o New Messages
 Post New Thread
 Reply to Message
 Post New Poll
 Submit Vote
 Delete My Own Post
 Delete My Own Thread
 Rate Posts


Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.

Forum Software © ASPPlayground.NET Advanced Edition 2.4

0.035