Encore Forums Encore Forums

Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums 

Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

ruler

 
Logged in as: Guest
  Printable Version
All Forums >> [Product Forums] >> [Productivity Software] >> Printmaster v8 Platinum (released 2017) >> ruler Page: [1]
Login
Message << Older Topic   Newer Topic >>
ruler - 6/7/2018 11:16:30 AM   
edcindee

 

Posts: 2
Joined: 6/7/2018
Status: offline
How do I put the ruler on my Printmaster v8 platinum? I have gone to the view but all that comes up is a box telling me it requires 8 gb or more of memory system and do I want to proceed. When I say yes it comes up a box that says it will restart my project, I say yes, and then we start all over again. There is not drop down list that has ruler listed in it like the help screen tells me.
Post #: 1
RE: ruler - 6/7/2018 11:45:36 AM   
ellengard


Posts: 3253
Joined: 10/2/2006
Status: offline
When you click on the View tab, make sure "Rulers" has a check next to it. Then you can click anywhere on the rulers to set a guide line.

Are you not getting this drop down menu?




Attachment (1)

(in reply to edcindee)
Post #: 2
RE: ruler - 6/8/2018 10:49:22 AM   
JasonC

 

Posts: 1692
Joined: 12/14/2005
From: Hayward, CA
Status: offline
Smooth Canvas Rendering would enable that message. Do not enable unless you have that system memory minimum. Your projects will still print out high quality regardless of the setting.

_____________________________

Jason Carver
Encore Sales Department and Customer Service
www.encore.com
For Tech Support, visit http://support.encore.com

(in reply to edcindee)
Post #: 3
Page:   [1]
All Forums >> [Product Forums] >> [Productivity Software] >> Printmaster v8 Platinum (released 2017) >> ruler Page: [1]
Jump to:





New Messages No New Messages
Hot Topic w/ New Messages Hot Topic w/o New Messages
Locked w/ New Messages Locked w/o New Messages
 Post New Thread
 Reply to Message
 Post New Poll
 Submit Vote
 Delete My Own Post
 Delete My Own Thread
 Rate Posts


Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.

Forum Software © ASPPlayground.NET Advanced Edition 2.4

0.031