I created a project to print address labels with about 90 addresses. If only a few addresses are selected, which I did to test the function, the project is rendered successfully. But when all 90 are selected the project rendering just never ends and locks up my computer. I started the rendering about 3 pm yesterday and it ran all night. My computer was still locked up the following morning and finally had to be turned off with the power button and back on. I wasn't even able to get to the Start button to do a shutdown that way.
Then I tried selecting 10 addresses and the rendering ended successfully but the preview was completely blank.
ORIGINAL: klesmiley1 ... If only a few addresses are selected, which I did to test the function, the project is rendered successfully. But when all 90 are selected the project rendering just never ends and locks up my computer...
You aren't doing anything wrong. Looks like a technical issue where the program can't handle a print job the size of 90 addresses.
You can submit a tech support ticket or work around the problem. Try doing the first 50 addresses. If that works, do the remaining.
Post New Thread
Reply to Message
Post New Poll
Delete My Own Post
Delete My Own Thread
Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.
If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.