Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 4.0 >> cd label printing outside of label

Page: [1]

Login Message << Older Topic   Newer Topic >>

cd label printing outside of label - 10/24/2015 2:07:34 AM    rxchax   Posts: 1 Joined: 10/24/2015 Status: offline Just started using The Print Shop Professional 4.0. I'm having problems with the label printing out side of the designated area. How should I make adjustments? I have a HP Officejet 6700 printer. Any one still up? Post #: 1

RE: cd label printing outside of label - 10/24/2015 2:36:11 AM    ellengard Posts: 3253 Joined: 10/2/2006 Status: offline You can compensate for misalignment if the misalignment is predictable. For example, if the print is consistently 2mm too far to the right, just group everything in your design and move it 2mm to the left. Then print. Your printer options probably have a way to reset alignment, but it's probably more complicated than the method above. It's important to know that it's normal for your printer to be off by 2mm. Printer feed variance. You could print 10 copies of the same project and the starting point of the printing would vary within 2mm for each copy. (in reply to rxchax) Post #: 2

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 4.0 >> cd label printing outside of label

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.