Encore Forums Encore Forums

Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums 

Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

PM 18: Installing on WinVista: "Not Responding" error message

 
Logged in as: Guest
  Printable Version
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM Tech Tips >> PM 18: Installing on WinVista: "Not Responding" error message Page: [1]
Login
Message << Older Topic   Newer Topic >>
PM 18: Installing on WinVista: "Not Responding&quo... - 11/16/2007 7:11:09 PM   
Brandy redux


Posts: 2376
Joined: 2/7/2007
Status: offline
When PrintMaster 18 is installed on any Operating System, the first thing that will happen is that the installation process will check to see if .net Framework 1.1 is already installed - because PrintMaster 18 cannot function without .net Framework 1.1.

If .net Framework 1.1 is not already installed, the installation process will install .net Framework 1.1 BEFORE proceeding to the actual installation of PrintMaster 18.

When I installed PrintMaster 18 on WinVista, .net Framework 1.1 was installed (as expected). But, after the .net Framework 1.1 installation had finished and before the actual PrintMaster 18 installation had begun, I received an error message which said that InstallShield was not responding. By the time I had opened Task Manager to make sure that the installation process was truly not responding, the installation process had continued on its own.

So, if you ever encounter a 'Not Responding' situation while attempting to install PrintMaster 18 on WinVista, just wait a minute or two to see if the installation will proceed on its own.

< Message edited by Brandy redux -- 8/16/2010 2:27:28 PM >


_____________________________

For More Help:
Click on the FAQ link at the top of this page
Then, click on the All FAQ's button on the next page

To contact me by email, please send your message to pine_97@yahoo.com
Post #: 1
Page:   [1]
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM Tech Tips >> PM 18: Installing on WinVista: "Not Responding" error message Page: [1]
Jump to:





New Messages No New Messages
Hot Topic w/ New Messages Hot Topic w/o New Messages
Locked w/ New Messages Locked w/o New Messages
 Post New Thread
 Reply to Message
 Post New Poll
 Submit Vote
 Delete My Own Post
 Delete My Own Thread
 Rate Posts


Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.

Forum Software © ASPPlayground.NET Advanced Edition 2.4

0.031