Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> [The Print Shop 23.1 and older] >> PS General functionality >> Borderless Business Cards

Page: [1]

Login Message << Older Topic   Newer Topic >>

Borderless Business Cards - 10/15/2005 8:32:53 PM    MG   Posts: 1 Joined: 10/15/2005 Status: offline I've tried and tried, and created new card stock after new stock and my buisness cards refuse to print out properly. I want to make them print on the full card, not smaller than the card so it leaves a border. How do I change the margins of the template so that the design fits on the whole card? < Message edited by Brandy redux -- 7/2/2007 7:45:14 PM > Post #: 1

RE: Borderless Business Cards - 10/15/2005 9:38:45 PM    Midge Posts: 90 Joined: 3/20/2005 Status: offline Hi MG, With the newer versions of Print Shop, it is not possible to change the margins of a pre-designed template so that the design fits on the whole business card. If you create a Custom Business Card Paper with the Custom Paper Wizard in the Tools menu, you can cause the design to fit on the whole card. But, in order to do so, you must click in the box next to the Full Bleed option while you are creating the Custom Business Card Paper. You will find the Full Bleed option on the same window where the inter-item spacing measurements are entered (Width, Height, Width+Gap, Height+Gap). < Message edited by Brandy redux -- 7/5/2010 2:32:35 PM > _____________________________ Never say "Never" - there's always an exception to every rule (in reply to MG) Post #: 2

All Forums >> [Product Forums] >> [Productivity Software] >> [The Print Shop 23.1 and older] >> PS General functionality >> Borderless Business Cards

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.