Would like some actual user information (Full Version)

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 4.0



Message

NorthGeorgia -> Would like some actual user information (10/23/2015 11:05:26 AM)

Hello, new member here.

I have been using Print Shop since the Windows XP days (maybe earlier?). My latest version is 23.0.0 . It runs fine on
Windows 7. I am contemplating upgrading to Windows 10, since it will be a free upgrade. But, I am slightly hesitant due to
the fact that 23.0.0 does not work on that OS. But I see that Print Shop 4.0 will. But again am hesitant because of some of
'doubts' I see about importing the old projects and items created with 23.0.0 . I was hoping that someone who has done
what I have described would share their experience and what problems they encountered. Maybe this should be posted to
the 3.5 forum.......too.

thanks



JasonC -> RE: Would like some actual user information (10/23/2015 12:14:42 PM)

You may want to see this post that was created: http://forums.encoreusa.com/tm.asp?m=50463

If your product has save as JPG, I would remove anything from a design you work with that is not going to be part of the project. Then export that project as a JPG. This image can be imported into Print Shop 4.0 and you can overlay additional graphics on top of the image you imported.

If you are upgrading from Windows 7 to Windows 10, please see the post I made here: http://forums.encoreusa.com/tm.asp?m=50382

Even though I designed this to apply to version 3.5, the same should apply to any version you have installed on your computer. I would backup the folder you have your projects save on before upgrading. And as the post I made says, remove any old version from your computer before you upgrade to Windows 10 and then install the newer version.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4
0.015625