work canvas (Full Version)

All Forums >> [Product Forums] >> [Productivity Software] >> Print Shop Mac (Encore 2015)



Message

sped2250 -> work canvas (4/11/2016 3:48:44 PM)

When I am working on a project, my working canvas or screen is very narrow. I am unable to see the entire project without reducing the image to 50%. Then it is too small to work upon. How can I enlarge my screen canvas?



ellengard -> RE: work canvas (4/11/2016 4:24:55 PM)

I don't know if it is the same with a Mac computer, but for PC, your screen resolution must be a minimum of 1024x768. If you have your display set for higher than 100% view, then your screen resolution must be set higher.



sped2250 -> RE: work canvas (4/11/2016 10:07:49 PM)

Thank you, Ellen. My screen display is set higher than 1024x768. The work canvas is not showing the entire area.



ellengard -> RE: work canvas (4/11/2016 10:57:34 PM)

Can you upload a screen capture to show the problem? It might give us a clue.



sped2250 -> RE: work canvas (4/12/2016 10:08:56 AM)

I tried to post a screen shot. I received this message:

C:\fakepath\Screen Shot 2016-04-11 at 3.46.17 PM.png is not supported.

If I select "embed picture in post, the image is too large to send.



JasonC -> RE: work canvas (4/12/2016 11:09:46 AM)

I have a Mac and will take a look at this now.



JasonC -> RE: work canvas (4/12/2016 11:23:04 AM)

See my Screenshot below. At the bottom right of the screen, is the zoom feature. Am I correct that this is not working? At the bottom of the screen is where it shows your active pages. This cannot be shutoff unfortunately.

If I go to View > Canvas Zoom > Fit To Window it does the best to fit your display for the whole size, but as ellengard mentioned, try setting your display size higher.

[image]local://upfiles/5151/D7660F269D36405A933ADD3DBDBF4D0C.jpg[/image]



ellengard -> RE: work canvas (4/12/2016 12:32:27 PM)

quote:

ORIGINAL: sped2250
My screen display is set higher than 1024x768. The work canvas is not showing the entire area.

After seeing Jason's screen capture, it appears to me that there is no problem because an entire project cannot be viewed unless zoomed out. One of the only projects that can be viewed in its entirety, at greater than 100% zoom, is a label project. A label is generally small.

A project that is for example, 8.5 x 11 inches, simply can't fit on a screen at 100%, when you have to also show the program's interface. When I put a piece of paper up to my screen, the paper is taller.

Like everyone else, I zoom in to work on specific areas of my project, then I zoom out to see the overall layout, then zoom in to work on another section.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4
0.015625