Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 3.5 >> printing help

Page: [1]

Login Message << Older Topic   Newer Topic >>

printing help - 10/13/2014 5:00:58 PM    lssnyder   Posts: 3 Joined: 10/13/2014 Status: offline Hello I have two questions. First I am trying to print a project that is 10x15 on multiple pages and not sure what to change in the output size?? Also I like to use a lot of different fonts and many of the cursive fonts are spaced to far apart. I changed the kerning to closer together and its still to far apart. Thanks so much. Post #: 1

RE: printing help - 10/13/2014 5:58:14 PM    ellengard Posts: 3253 Joined: 10/2/2006 Status: offline To print a poster on multiple pages, it's best to design the poster on standard letter size page. Then go to print and click the Output Size button. From there, you can rescale the poster to print on as many sheets of paper as you want. Headline kerning is exactly what you see. It can only go as far as the extreme ends of the slider. If it's a very short headline, you can create each letter individually and push each letter as close together as you want. If you created a custom size page of 10x15, the program expects you'll be printing it on a sheet of that size. So you could save it as PDF, that size. Then open the PDF in Adobe Reader and use its poster print options which allow you to "tile" your large page onto the smaller letter size sheets. < Message edited by ellengard -- 10/13/2014 6:10:14 PM > (in reply to lssnyder) Post #: 2

RE: printing help - 10/13/2014 6:17:07 PM    lssnyder   Posts: 3 Joined: 10/13/2014 Status: offline Thank you so much for getting back to me so quickly. But how do I figure out how many pages I need to print? For example say I need to print something to fit a 10x15? I can't figure out how many pages that should be to be exact? I thought maybe that is what I needed to do for the kerning. (in reply to ellengard) Post #: 3

RE: printing help - 10/13/2014 6:18:45 PM    lssnyder   Posts: 3 Joined: 10/13/2014 Status: offline I will have to try and print it from adobe. I apologize I didn't see you write that. ;) (in reply to lssnyder) Post #: 4

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 3.5 >> printing help

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.