Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> How do I create a landscape Iron-On?

Page: [1]

Login Message << Older Topic   Newer Topic >>

How do I create a landscape Iron-On? - 12/12/2008 6:27:41 AM    ckpink80   Posts: 1 Joined: 12/12/2008 Status: offline I'm trying to create an iron on and I can not get the page to landscape? Even if I change the printer to landscape the text area never changes and the print preview is never correct any suggestions? < Message edited by Brandy redux -- 6/20/2010 7:24:05 PM > Post #: 1

RE: How do I create a landscape Iron-On? - 12/12/2008 9:54:53 AM    lindarobin Posts: 947 Joined: 8/28/2004 Status: offline The iron on project only has portrait orientation, so the easiest workaround is to design everything as if it is landscape orientation. When that's done, select all, group and rotate 90 degrees. Another alternative is to open a blank page wide project. But then it's up to you to select all, group and flip mirror image. Unless your printer has a special iron on setting that mirror flips it again! I recommend you test your print settings on plain paper to make sure the printing comes out mirror flipped. Save your ink - print only a test line of text. < Message edited by Brandy redux -- 10/1/2012 11:58:49 AM > (in reply to ckpink80) Post #: 2

All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> How do I create a landscape Iron-On?

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.