saving to landscape to pdf (Full Version)

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 3.0



Message

lisaannp -> saving to landscape to pdf (12/8/2011 6:15:30 PM)

when trying to save a project that is set up in landscape when saving to PDF it save it in portrait and cut off half of the project. Does anyone have a solution



Brandy redux -> RE: saving to landscape to pdf (12/8/2011 6:26:25 PM)

Hi lisaannp,

The problem you described is a known problem, for which there is no solution - YET. The fix for this problem will be included in the 3.0.5 update for Print Shop 3.0, which has been repeatedly delayed - for technical reasons.



ellengard -> RE: saving to landscape to pdf (12/8/2011 10:31:50 PM)

I never installed the previous update patch, so my results may be different than yours. When I opened a landscape project, I could save it as JPG and it was fine, i.e. not cut off.

So if you can save your project as a high res JPG, that may provide you with a workable substitute for the PDF.



Brandy redux -> RE: saving to landscape to pdf (12/15/2011 8:27:23 PM)

UPDATE: I have just discovered that, after the 3.0.5 patch is released, Landscape projects which are saved with the Save button will no longer be saved in Portrait orientation. However, the 3.0.5 patch does not fix the problem with the 'Save as PDF' option. So, when Landscape projects are saved to PDF, those projects will still be saved in Portrait orientation, even after the 3.0.5 patch is released.



Page: [1]

Valid CSS!




Forum Software © ASPPlayground.NET Advanced Edition 2.4
1.367188E-02