Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 3.0 >> saving to landscape to pdf

Page: [1]

Login Message << Older Topic   Newer Topic >>

saving to landscape to pdf - 12/8/2011 6:15:30 PM    lisaannp   Posts: 1 Joined: 12/8/2011 Status: offline when trying to save a project that is set up in landscape when saving to PDF it save it in portrait and cut off half of the project. Does anyone have a solution Post #: 1

RE: saving to landscape to pdf - 12/8/2011 6:26:25 PM    Brandy redux Posts: 2376 Joined: 2/7/2007 Status: offline Hi lisaannp, The problem you described is a known problem, for which there is no solution - YET. The fix for this problem will be included in the 3.0.5 update for Print Shop 3.0, which has been repeatedly delayed - for technical reasons. _____________________________ For More Help: Click on the FAQ link at the top of this page Then, click on the All FAQ's button on the next page To contact me by email, please send your message to pine_97@yahoo.com (in reply to lisaannp) Post #: 2

RE: saving to landscape to pdf - 12/8/2011 10:31:50 PM    ellengard Posts: 3253 Joined: 10/2/2006 Status: offline I never installed the previous update patch, so my results may be different than yours. When I opened a landscape project, I could save it as JPG and it was fine, i.e. not cut off. So if you can save your project as a high res JPG, that may provide you with a workable substitute for the PDF. (in reply to lisaannp) Post #: 3

RE: saving to landscape to pdf - 12/15/2011 8:27:23 PM    Brandy redux Posts: 2376 Joined: 2/7/2007 Status: offline UPDATE: I have just discovered that, after the 3.0.5 patch is released, Landscape projects which are saved with the Save button will no longer be saved in Portrait orientation. However, the 3.0.5 patch does not fix the problem with the 'Save as PDF' option. So, when Landscape projects are saved to PDF, those projects will still be saved in Portrait orientation, even after the 3.0.5 patch is released. _____________________________ For More Help: Click on the FAQ link at the top of this page Then, click on the All FAQ's button on the next page To contact me by email, please send your message to pine_97@yahoo.com (in reply to ellengard) Post #: 4

All Forums >> [Product Forums] >> [Productivity Software] >> The Print Shop 3.0 >> saving to landscape to pdf

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.