Encore Forums Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums  Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

Printable Version

All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> PM Plat 16: Cannot type in table cells

Page: [1]

Login Message << Older Topic   Newer Topic >>

PM Plat 16: Cannot type in table cells - 11/24/2010 7:05:43 AM    jinky   Posts: 35 Joined: 11/15/2009 Status: offline I have Platinum 16 and cannot use Tables. I can form the table ok but then cannot type in the cells. < Message edited by Brandy redux -- 1/2/2011 9:37:42 PM > Post #: 1

RE: PM Plat 16: Cannot type in table cells - 11/24/2010 10:03:39 AM    ellengard Posts: 3253 Joined: 10/2/2006 Status: offline Double-click inside a cell and start typing. The default size is 3 (too small), so I click and drag to select all the cells, then change the font size to 12 or higher. < Message edited by Brandy redux -- 1/2/2011 9:37:49 PM > (in reply to jinky) Post #: 2

All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> PM Plat 16: Cannot type in table cells

Page: [1]

New Messages No New Messages Hot Topic w/ New Messages Hot Topic w/o New Messages Locked w/ New Messages Locked w/o New Messages

Post New Thread  Reply to Message  Post New Poll  Submit Vote  Delete My Own Post  Delete My Own Thread  Rate Posts

Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.