Encore Forums Encore Forums

Knowledgebase  Register  Login  My Profile  Inbox  Address Book  My Subscription  My Forums 

Photo Gallery  Member List  Search  Calendars  FAQ  Ticket List  Log Out

rotate tool?

 
Logged in as: Guest
  Printable Version
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> rotate tool? Page: [1]
Login
Message << Older Topic   Newer Topic >>
rotate tool? - 9/29/2004 5:35:06 AM   
sja264

 

Posts: 1
Joined: 9/29/2004
Status: offline
I have just begun using PrintMaster Platinum 16. I have a graphic that I would like to rotate a certain number of degrees. The HELP menu says to use the rotate tool in the toolbar, but I can't seem to see a rotate tool. Can anybody help??
Post #: 1
RE: rotate tool? - 9/29/2004 7:48:41 AM   
PamE

 

Posts: 48
Joined: 8/2/2004
Status: offline
Open a project and insert an image. Do you see a status bar along the bottom of the screen that contain ZOOM in the lower left corner, etc.? If so, at the very far right is the ROTATION tool. With the image selected in the project, when I click on the ROTATION TOOL, a window pops up, where I can select MORE. This will allow you to type in a certain value.

If you don't see the status bar at all, perhaps you have your program settings to not show it? See the VIEW menu at the top of the program. Select TOOLBARS > STATUS BAR from that menu. Otherwise, if that doesn't work, we might need to point you in a different direction to get that resolved. Let us know.

< Message edited by PamE -- 9/29/2004 7:52:40 AM >

(in reply to sja264)
Post #: 2
Page:   [1]
All Forums >> [Product Forums] >> [Productivity Software] >> [PrintMaster 18.1 and older] >> PM General Functionality >> rotate tool? Page: [1]
Jump to:





New Messages No New Messages
Hot Topic w/ New Messages Hot Topic w/o New Messages
Locked w/ New Messages Locked w/o New Messages
 Post New Thread
 Reply to Message
 Post New Poll
 Submit Vote
 Delete My Own Post
 Delete My Own Thread
 Rate Posts


Please Note: In order to post a message on the forums, you will need to become an Encore Forum Member. Click on the Register link on the top of this page and follow the instructions to become an Encore Forum Member.

If you are a new member and need help using these forums, please click on the FAQ link at the top of this page.

Forum Software © ASPPlayground.NET Advanced Edition 2.4

1.219